Serving Pearland and Brazoria County and south Houston since 2009
Licensed & InsuredFree EstimatesMon-Fri 7am-6pm
(346) 586-8503 Licensed & Insured
Book a Free Foundation Inspection
Pier and Beam Foundation Repair in Pearland, TX

Pier and Beam Foundation Repair in Pearland, TX

Pearland Superior Foundation Repair offers professional pier and beam foundation repair in Pearland, TX with crews led by an owner who has worked under houses since 1998. We replace rotted wood posts and crumbling block piers with poured concrete piers, re-level sagging floors on steel shims, and sister or replace rotted sill plates, beams and joists. Most re-levels are done in 1 to 2 days.

Pier and beam homes move differently from slabs. The floor sags between piers, bounces near the kitchen, or slopes toward one wall, and the fix is usually a mix of new piers, shimming and wood repair. We also handle crawl space moisture, vapor barriers and access, and every new pier we set carries a lifetime transferable warranty.

Get a FREE Estimate

Or call (346) 586-8503

  • Steel shims only, never wood that crushes and rots
  • New poured concrete piers at $375 to $650 each
  • Rotted sill and beam work priced per linear foot, $40 to $75
  • Most re-levels finished in 1 to 2 days

Pier and Beam Repair Options

Pier and Beam Shim Re-Leveling

Pier and Beam Shim Re-Leveling

When the piers are sound but the floor has drifted, we jack the beams back up and swap the old shims for steel. A shim re-level runs $950 to $2,800, depending on how many piers need adjusting.

Pier and Beam Pier Replacement

Pier and Beam Pier Replacement

Old cedar posts rot at the soil line, and stacked block piers tip or crumble. We dig them out and set new poured concrete piers, $375 to $650 each, sized to the load they carry.

Pier and Beam Sill Plate and Beam Repair

Pier and Beam Sill Plate and Beam Repair

Termites and moisture go after the sill plate first, the board that sits on the perimeter. We sister a new member alongside a damaged one or replace the section outright, at $40 to $75 per linear foot.

Pier and Beam Joist Sistering for Bouncy Floors

Pier and Beam Joist Sistering for Bouncy Floors

A floor that bounces in front of the fridge or tub usually has undersized or cracked joists. We sister new lumber alongside them, and add a beam line on new piers when the span is too long.

Pier and Beam Perimeter Beam Piering

Pier and Beam Perimeter Beam Piering

Some older homes carry the exterior walls on a concrete perimeter beam. When that beam drops, we pier it with pressed concrete pilings the same way we would a slab edge, pressed to refusal, usually 10 to 20 feet down.

Before and After

Crumbling block piers and rotted post under a sagging girder in a Pearland crawl space
Poured concrete piers with steel shims under a straight girder in a pier and beam crawl space
Typical before and after: crumbling block piers and a rotted post replaced with poured concrete piers and steel shims.

Signs Your Pier and Beam Foundation Needs Work

You'll usually feel pier and beam problems before you see them. Floors slope enough that a marble rolls, a soft spot shows up in front of the sink, or the china cabinet rattles when someone walks past.

Outside, look for a skirt or perimeter wall that's cracked or pulling away. Inside, look for gaps at the top of door frames. In the crawl space the story is plain: tipped piers, crushed wood shims and dark, damp wood along the sill.

Moisture Under the House

Standing water after rain, a musty smell inside, and sweating ductwork all mean the crawl space is wet. Wet clay under a pier lets it sink, and wet wood rots. Fixing the moisture is part of the repair, not an extra.

Clearance and Access

We need about 18 inches of clearance to work comfortably. Joists closer than 18 inches to the dirt are the ones we see rot first, and tight crawl spaces sometimes need a small trench dug so we can reach the back piers.

Why Wood Shims and Old Piers Fail Here

Gulf Coast humidity is hard on anything wood under a house. Wood shims compress under load and then soften when the crawl space stays damp, so a floor that was level after the last repair drifts back down within a few seasons.

Old piers have their own problems. Cedar posts were set straight into the clay and rot from the soil line up. Concrete block piers sit on small pads that tilt when the clay under them swells unevenly.

That's why our re-levels use steel shims and why replacement piers are poured concrete. We'd rather do it once than come back and do it again.

Why Owners of Older Homes Call Us

Pier and beam work is slower and dirtier than slab work, and plenty of companies would rather not crawl. We take it on purpose. Luis has been under houses since 1998 and still goes into the crawl space on inspections.

We'll tell you which problems are structural and which are cosmetic. A sloped floor from one sunken pier is a quick fix. A sloped floor from a rotted sill line is a bigger job, and you deserve to know which one you have before you see a price.

If the crawl space needs moisture control too, we can add a vapor barrier or a full encapsulation with a 20-mil reinforced liner so the new wood stays dry.

Our Pier and Beam Repair Process

  1. Crawl space inspection

    We go under the house, check every pier, shim and sill section we can reach, and shoot the floor with the manometer.

  2. Engineer's plan and written quote

    For pier replacement or beam work, an independent engineer writes the plan. Your quote is line by line: piers, shims and linear feet of wood.

  3. Pier work

    Rotted posts and failed block piers come out. New poured concrete piers go in, sized to the load above them.

  4. Wood repair and re-level

    Damaged sills and joists get sistered or replaced, then we jack the beams up together and set steel shims.

  5. Final readings and cleanup

    We shoot the floor again, check doors and windows, pull debris out of the crawl space and hand you the warranty.

Pier and Beam Repair Questions

How much does pier and beam foundation repair cost?

A shim re-level runs $950 to $2,800. New concrete piers are $375 to $650 each, and rotted sill or beam replacement is $40 to $75 per linear foot. Most jobs are a mix, priced line by line.

Do I have to move out during the repair?

No. We work from the crawl space and the yard. You'll hear jacks and some hammering, and we'll ask you to clear the area around the access opening.

My floor bounces but isn't sloped. Is that a foundation problem?

Usually it's the joists, not the piers. Undersized or cracked joists get sistered with new lumber, and sometimes we add a beam line on new piers to shorten the span.

Should I convert my pier and beam house to a slab?

Almost never. It's expensive and you lose easy access to the plumbing. A pier and beam house with sound piers, steel shims and a dry crawl space holds up fine on this clay.

Is termite damage part of the repair?

We replace or sister wood that termites damaged, but we're not exterminators. Have a licensed pest control company treat first, then we fix the structure.

Get Under the House With Us

Call (346) 586-8503 and we'll inspect the crawl space, shoot your floors and give you a written, line-by-line quote.